Rosemount 8712C - Page 107

I-1
INDEX
A
Accuracy ......................... 6-3
Action Keys
HART Communicator ..........A-6
Alphanumeric Keys
HART Communicator ..........A-6
Ambient Temperature Limits .... 6-1
Analog Output
adjustment ................... 6-2
range ......................... 4-6
test ...................4-3,5-5,6-2
zero .......................... 4-7
Applications/Configurations ..... 2-3
Auxiliary Output .......2-12,4-12,6-2
B
Base Time Unit ................. 4-12
Basic Setup ...................... 4-6
C
Cable Requirements ............. 6-5
Canadian Standards
Association (CSA) Approval
.... 6-3
Coil Drive Frequency ........... 4-13
Conductivity Limits ............. 6-1
Conduit
cables .....................2-6,2-7
connections ................... 2-6
Configuration Data Sheet (CDS) .6-8
Configurations/Applications ..... 2-3
Connections
HART Communicator ..........A-4
ports ......................... 5-8
Control Status .................. 4-14
D
Damping ........................ 6-3
Data Entry
HART Communicator ..........A-7
Date ............................ 4-16
Description, system .............. 1-2
Detailed Setup ................... 4-9
Device Software Functions .......4-1
basic setup .....................4-6
detailed setup ..................4-9
diagnostics and service ..........4-3
miscellaneous functions ........4-16
multidrop communications .....4-18
process variables ...............4-2
review variables ...............4-15
Diagnostic Messages
HART Communicator ..........A-9
LOI ...........................3-4
Diagnostics and Service ..........4-3
Dimensions
dimensional drawing ...........2-2
transmitter ....................6-5
E
Electrical
connections ....................6-5
considerations ..................2-5
Electrical Considerations .........2-5
input power ....................2-7
wire lengths ...................2-8
Electronics
connection ports ................5-8
installation ....................5-9
module replacement ............5-7
removing ......................5-7
trim ...........................4-4
Enclosure Ratings ................6-2
Environmental Considerations ...2-3
Exploded Parts Drawing ..........6-7
F
Factory Mutual (FM) Approval ...6-3
Failure Alarm Mode ..............2-4
Fast Key
features ......................A-7
sequence table ................A-3
Flow Rate
range ..........................6-1
units ..........................4-6
Flowtube
coil resistance ..................6-1
compatibility ...................6-1
compensation ..................6-3
connections ...................2-14
gain ..........................4-16