Rotax 912 Series Installation Manual

d04919.fm
INSTALLATION MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2/Rev. 0
10-10-00
page 5
August 01/2012
1.4) Protective covering
General note
All openings are protected against ingress of contamination and damp-
ness. It is recommended to leave the protective plugs in place until instal-
lation of the specific feed line.
NOTE: The transport equipment and plugs must be reattached if
the engine will be sent to the manufacturer or distributor.
Protective cover-
ing
List of protective covering:

WARNUNG
NOTICE
Protective coverings are only for use during transport
and engine installation. They must be removed before
the engine is operated.
Installation place Number
Exhaust socket 1x cone plug
Connection for manifold pressure 1x cap
Airbox 2x cap
Fuel pump inlet 1x cap
Connection for fuel return 1x plug
Connection for fuel pressure 1x plug
Oil supply and oil discharge 1x each cap
Supply and discharge of coolant 1x each cone plug
Propshaft on configuration 3 1x disk plug
Carburetor (if not equipped with an airbox) 2x disk plug

Rotax 912 Series Specifications

General

Redline	5800 rpm
TBO	2000 hours
Displacement	1211 cc
Bore	79.5 mm
Stroke	61 mm
Power Output	80 hp (59.6 kW)
Compression Ratio	9.0:1
Fuel Type	Avgas 100LL
Ignition System	Dual electronic ignition
Fuel System	Fuel Injected
Oil System	Dry sump
Engine Type	4-cylinder, horizontally opposed, 4-stroke