Slip control button
This command selects the corresponding control function. The
colour of the left hand lamp will indicate whether this function has
been activated as a main (red) or secondary (green) control.
NB: This function will be active only if the lift system is equipped
with wheelslip control.
Position control button
This button selects the corresponding control function. The colour
of the left hand lamp will indicate whether this function has been
activated as a main (red) or secondary (green) control.
Draft control button
This button selects the corresponding control function. The colour
of the left hand lamp will indicate whether this function has been
activated as a main (red) or secondary (green) control.
Maximum lift height control
Activates and deactivates the facility of limiting the maximum lift
height. Pressing the switch, the red indicator alongside lights up
and the system memorizes the position of the lift arms. Every time
the Up control is operated thereafter, the lift arms will cease
upward movement at the memorized limit position
Block or transport button (Maximum height)
Activates and de-activates total block of the control panel. The red
lamp next to the button is illuminated when function is activated.
NB: Pressing the switch, the control unit immediately pilots the
lift ram to elevate the implement to the maximum height (effectively
the transport position).
STOP
Temporarily stops lift movement; the red lamp next to the button
is illuminated when function is activated.
Caution: this control is especially important, as it allows the
hydraulic lift to be immobilized immediately in the event of danger.
ALARM INDICATOR
In the event of a fault affecting one or more components of the
system, a red indicator will blink.
Draft, position and wheelslip control
Maximum lift height limit control
Position lock or transport control
STOP
ALARM INDICATOR
59
5
vehicle
electronic power-lift
229
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...
