Samsung R40plus - Page 150

149
Q
In the following cases, the screen blinks or
displays noise for a short time (This only applies
to nVidia graphics card.): (Click the Graphics
Related tab, Change Resolution, Change Display
Device, Remove the AC Adapter, Restart the
System, Change PowerMizer level.)
A Thismayhappenwhilethevideodriverisexaminingthe
connecteddevice.Whiledetecting,anyconnecteddisplay
devicesmayblinkorsomenoisemayoccur.
Q
When I connect a projector, and change the
setting to display screen image on both the LCD
and the projector by pressing Fn + ( ) keys,
screen is not displayed properly.
A Press Fn + ( )keysonceagain.Ifthesameproblem
continues,itmeanstheprojectorcannotsupportthe
resolution.Lowertheresolutionto1024x768.
Q
The playback screen of a DVD title or an MPEG
le is only displayed on the LCD. (This only
applies to nVidia graphics card.)
A Videoisdisplayedonasingledisplaydevicebydefault,
when LCD and CRT are selected simultaneously.

Right-clickovertheDesktop and select Properties
fromthepop-upmenu.
 In the Display Properties
window,selectSettings
tab> Advanced > Ge-Force Go xxxx
tab.
 Select the Full Screen Video menu > Full Screen
Video Control
item,setthefullscreendeviceto
“AuxiliaryDisplay”andthenclicktheApply
button.
ThenyoucanviewvideoonboththeLCDandCRT
display devices.
Q
The Taskbar on the bottom of the screen does
not appear when a projector is used as the
display device.
A AThismayhappen,eventhoughSXGA+LCDsupports
the1400x1050mode,theprojectordoesnotsupportthat
mode. In this case change the resolution to 1024
x768
(recommended) on your computer.