155
A2 The<WakeOnLAN>functionisconguredsothatitis
supported in Standby mode (S
3). To use this function
in Hibernation
mode(S4)orintheTurnOff(S5)state,
congureitasfollows:
Enter BIOS SETUP and select the Boot menu.
Move to the Wake On Lan item and press the Enter
key. Change it from Disabled to Enabled and press
the Enter key.
Q
When I connected 100Mbps wired LAN and
the computer exits standby/hibernate mode,
a message informing 10Mbps wired LAN
connection appears.
A Whenthecomputerexitsstandby/hibernatemode,
restoringthenetworktakesabout3seconds.Whenthe
networkisrestored,itoperatesin100Mbps.
Q
How can I use the maximum network
performance?
A Setupthefollowingoptionstousethemaximumnetwork
performance.
Click Start > Control Panel > Performance and
Maintenance > System > Hardware tab > Device
Manager.
SelectNetworkAdapterandthenRealtek RTL8139/
810x Family Fast Ethernet NIC.
Right-clickoverthe
selection and select Properties
fromthepop-upmenu.
Select Properties in the Advanced tap and select
Optimal Performance. Set the value item to Enable.
Click the OK
button.
Q
I cannot nd an AP.
▶ Check the Wireless LAN LED.
A CheckiftheWirelessLANLEDison.Ifoff,pressthe
Wireless LAN On/Off
button<Fn>+<F9> to turn it on.
▶ Reinstall the driver.
A Reinstall the driver using the software media.
▶ Check the Wireless Zero Conguration (WZC) service.
A If
the“Windowscannotmakethiswirelessconnection”
messageappearswhilesearchingforwirelessnetworks,
itindicatesthataprogramotherthanWindowsissetto
managethewirelessLANsettings.
▶ To use the wireless LAN settings using Windows:
A Click Start > Control Panel > Network and Internet
Connections > Network Connections > Wireless
LAN Connection,
right-clickandcheckifthe“Windows
manageswirelessnetworksettings(W)”optionisselected
in the Wireless Network
taboftheProperties window. If
not,selecttheoption.
Wireless LAN Related