Samsung R40plus - Setting a Boot Password

129
Setting a Supervisor Password
A Supervisor Password is required to turn the computer
on or to start the System Setup.
WhensettingaSupervisorPassword,usersotherthana
supervisor cannot use the computer.
1
Select the Security menu in the BIOS Setup.
2
In the Set Supervisor Passworditem,press
<Enter>.
3
 Enterapassword,press<Enter>,re-enterthe
passwordforconrmation,andpress<Enter> again.
Thepasswordcanbeupto7alphanumeric
characters. Special characters are not allowed.
4
 Whenamessageconrmingthepassword
congurationappearsinthe[Setup Notice]window,
press <Enter>.
Thesupervisorpasswordhasbeenset.The
supervisor password is required to turn the computer
on or to enter the BIOS Setup.
Setting a Boot Password
Whensettingapassword,youhavetoenterapasswordtousethecomputerorentertheBIOSSetup.
Byconguringapassword,youcanrestrictsystemaccesstoauthorizedusersonlyandprotectdataandlessaved
on the computer.
Before You Start!
Do not lose or forget your password.
Ifyouhaveforgottenyourpassword,contactaSamsungservicecenter.Inthiscase,aservicefeewillbecharged.