Network Board: FDM Replacement
Network Board: FDM Replacement
Disassemble the set as the picture (refer to the set
disassembly diagram) and remove the current FDM
from CN2000 and insert the new FDM.
▶ Use the supplied JIG or a sharp object like a tweezers
to remove the FDM Holder at the corner grooves of both
sides. (Note that there can be a malfunction in the
monitor if the Socket is damaged.) Hold both sides and ▶
remove the FDM.
▶ Replace with the new FDM and assemble the set.
FDM Replacement
You may replace the FDM in the same or similar cases as followings:
-.EX1) Picture is normal but the remote control or function key does not work.
-.EX2) The SAMSUNG Logo appears but cannot perform the next step.
-.EX3) Upgrading for the Software problem is in need because the problem was found after the mass production.
CN6_FDM (DM234G20H20P )
1109-001362
The programmed FDM
To Next Page
Loading...
