Branch Feeder Monitor 136_Installation Operation and Manual 2
LIMITED WARRANTY
The manufacturer offers the customer a 24-month functional warranty on the instrument for
faulty workmanship or parts from date of dispatch from the distributor. In all cases, this
warranty is valid for 36 months from the date of production. This warranty is on a return to
factory basis.
This warranty is only applicable to SATEC instruments using HACS SATEC current
transformers.
The manufacturer does not accept liability for any damage caused by instrument malfunction.
The manufacturer accepts no responsibility for the suitability of the instrument to the
application for which it was purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void
the warranty.
Only a duly authorized representative of the manufacturer may open your instrument. The unit
should only be opened in a fully anti-static environment. Failure to do so may damage the
electronic components and will void the warranty.
The greatest care has been taken to manufacture and calibrate your instrument. However,
these instructions do not cover all possible contingencies that may arise during installation,
operation or maintenance, and all details and variations of this equipment are not covered by
these instructions.
For additional information regarding installation, operation or maintenance of this instrument,
contact the manufacturer or your local representative or distributor.
All trademarks are property of their respective owners.
July 2024
Copyright 2005-2024 © SATEC Ltd.
To Next Page
Loading...
