Satec BFM 136 - Appendix F Device Diagnostic Codes

Appendix F Device Diagnostic Codes
Branch Feeder Monitor 136_Installation Operation and Manual 72
Appendix F Device Diagnostic Codes
Diagnostic
Code
Startup Display
Message
Description
Reason
2
RAM/Data Error
Memory/Data error
Hardware failure
3
WDT Reset
Hardware watchdog reset
Hardware failure
4
Sampling Fault
Sampling fault
Hardware failure
5
CPU Exception
CPU exception
Hardware failure
6
Run-Time Error
Run-time software error
Hardware failure
7
Software Exception
Software watchdog timeout
Hardware failure
8
Power Up
Power Down/Up
Loss of power. Normal power-up sequence
9
External Reset
Warm restart/Device reset
External restart via communications or by
firmware upgrade
10
Configuration reset
Corrupted setup data has been replaced with
the default configuration
11
RTC fault
The clock time has been lost
14
Expanded memory/Data
flash fault
Hardware failure
See Device Diagnostics in Chapter 2 for more information on the BFM136 built-in diagnostics.