Satec BFM 136 - Configuring Expertpower Client

Chapter 4 PAS Application Software Changing Port Settings
Branch Feeder Monitor 136_Installation Operation and Manual 43
4.5.4 Configuring eXpertPower Client
The BFM136 has an embedded eXpertPowerTM client that provides communications with the
eXpertPowerTM server – the SATEC proprietary Internet services. Connections to the eXpertPowerTM
server are handled on a periodic basis.
To enter the Setup dialog, select the site from the list box on the PAS toolbar, select Communication Setup
from the Meter Setup menu, and then click the ExpertPower Client Setup tab.
The following table lists available options. Refer to your eXpertPower service provider for the correct
eXpertPower settings.
Parameter
Options
Default
Description
XPW Server IP Address
207.232.60.18
The IP address of the eXpertPower server
XPW Server Port
0-65535
5001
The TCP service port of the eXpertPower server
XPW Client Enabled
NO, YES
NO
Enables operations of the eXpertPower client
Time to Next Session, min
1-99999
The time remaining to the next connection session
NOTES
1. If you do not use the eXpertPowerTM service, do not enable the eXpertPower client in your
device.
2. Do not change the connection period setting. The eXpertPower server updates it automatically.