PM130 PLUS Powermeter Series 7
2. Power the PM130 PLUS unit on.
Assembling a module
To operate the PM130 PLUS:
1. Perform device diagnostics.
2. Configure the device through the PM130 PLUS unit front panel display.
Configuring the PM130 PLUS remotely
1. Install the PAS application software on your PC.
2. Configure the PAS database for your meter.
3. Configure the PAS communications settings.
4. Upgrade the meter firmware if a new version is available.
5. Set up the meter using the PAS application software.
6. Configure your security settings through the meter security setup.
7. Configure your communication protocol settings.
To Next Page
Loading...
