Satec PM130E User Manual

Chapter 5 Configuring T H E P M 1 3 0 P L U S
Configuring C O M M U N I C A T I O N S
72 PM130 PLUS Powermeter Series
The following table lists available GPRS options.
Table 16: GPRS Setup Options
Parameter
Default
Description
Access Point Name (APN)
internetg
The mobile network APN name
User name
Username (if required)
Password
Password (if required)
2. Configure your mobile network APN, username, password and GPRS
Client/Server mode. Consult your network operator regarding proper
network settings. Leave the username and password fields blank if
network authorization is not required.
3. Send your GPRS settings to the meter.
4. Select the GPRS interface in the COM2 port setup (see Setting Up
Serial Communication Ports).
5. Configure your eXpertPower client (see Setting Up eXpertPower
Client) or/and TCP Notification client (see Setting Up TCP Notification
Client) for communicating with a remote server.
You can check the status of the GPRS communications from the front
panel via the Status Display or via the Device Control dialog in PAS (see
Viewing Communication Status and Statistics).
Setting Up eXpertPower Client
The PM130 PLUS has an embedded eXpertPower
TM
client that provides
communications with the eXpertPower
TM
server – the SATEC proprietary
Internet services. Connections to the eXpertPower
TM
server are handled
on a periodic basis.
To set up communications with the eXpertPower
TM
server, select
Communication Setup from the Meter Setup menu, and then click on
the ExpertPower Client Setup tab.

Satec PM130E Specifications

General

Brand	Satec
Model	PM130E
Category	Measuring Instruments
Language	English