Satec PM130E - Page 70

Chapter 5 Configuring T H E P M 1 3 0 P L U S
Configuring C O M M U N I C A T I O N S
70 PM130 PLUS Powermeter Series
Using PAS
Select Communications Setup from the Meter Setup menu, and then
click on the Network Setup tab.
Figure 5-2: Communication Setup Dialog Box – Network Setup Tab
The table below lists available network options.
Table 15: Ethernet Setup Options
Display Label
Parameter
Options
Default
A
Device IP Address
192.168.0.203
-
Network Subnet Mask
255.255.255.0
G
Network Default Gateway
192.168.0.1
-
TCP Service Port
502 = Modbus/TCP
20000 = DNP3/TCP
502