Chapter 5 Configuring T H E P M 1 3 0 P L U S
Configuring M E T E R S E C U R I T Y
94 PM130 PLUS Powermeter Series
communications unless you provide a correct password.
If you cannot provide a proper password, contact your local
distributor for the appropriate password to override
password protection.
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, select
Administration from the Monitor menu, and then select Change
Password -> Password 1.
Figure 5-14: Password Setup Dialog Box
To change the password:
1. Type in a new 4-digit password
2. Repeat the password in the Confirm new password box
3. Check Enable password protection to enable password checking
4. Click Send.
To Next Page
Loading...
