SATEL VERSA 11
2.1.7 Entering data by means of the VERSA-LCD-GR keypad
The data being entered are presented on the display. The method of programming depends
on the type of data to be entered by service function. To save the data in the control panel,
press the
key. To exit the function without saving the changes, press the key.
Selection from the single-choice list
The upper line of display shows the function name, and the lower one – the currently
selected item. To scroll through the item list, use the keys (down) and the
keys (up). The and keys are not used.
Selection from the multiple-choice list
The upper line of display shows the function name, and the lower one – one of the items
to choose from. To scroll through the item list, use the keys (down) and the
keys (up). Shown in the upper right corner of the display is an additional symbol:
– displayed item is selected / option is enabled;
– displayed item is not selected / option is disabled.
Press any numerical key to change the currently shown symbol for another one.
Press the
or key to switch over the keypad to the graphical mode
programming. By means of the
and symbols, the display presents the current
status of all items accessible within this function (these can be e.g. zones, outputs,
options, etc.). The key moves the cursor to the right, and the key – to the
left. When you press the or key, the keypad returns to the text mode.
Entering decimal values
Digits are entered by pressing the suitable keys. The key moves the cursor to the
right, and the or key – to the left.
Entering hexadecimal values
Digits are entered by pressing the suitable keys. Characters from A to F available under
the
and
keys. Keep pressing the keys until the required character appears.
The
key moves the cursor to the right, and the or key – to the left.
Programming telephone numbers
Keep pressing particular keys until the required character appears. Characters available
in the keypad are presented in Table 1. Up to 16 characters can be programmed. Some
of the special characters (a, b, c, d, # and
) are coded so that the character takes up
two items, hence the maximum number of characters available for entering, if they are
used, will be lower.
Shown on the right side in the upper line of the display is information about the letter
case: [ABC] or [abc] (it will be displayed after pressing any key and will be visible for
a few seconds after the last keystroke).
The key moves the cursor to the right, and the or key – to the left.
The key deletes the character on the left side of the cursor.
To Next Page
Loading...
