20 Programming Manual SATEL
4. The DLOADX program will signal establishing communication by displaying an appropriate
message.
2.2.7 Finishing local programming
The local programming function will stop automatically after 4 hours have elapsed since
operation of the DLOADX program was completed. The function may also be terminated by
using the FINISH DWNLRS command, available from the keypad.
1. Enter in the keypad the service code (by default 12345) and press the key.
2. Press in turn the
keys (to start the FINISH DWNLRS function).
2.2.8 Starting remote programming via modem
For remote programming to be possible, the modem and the control panel must be suitably
configured. Communication between the control panel and the modem can be established in
a few ways:
1. Connection is initiated from the DLOADX program.
2. Connection is initiated from the DLOADX program, but the control panel calls back and
establishes the connection.
3. Connection is initiated by the control panel.
Configuring settings of modem connected to computer
Configuration of the modem connected to computer is possible by using the DLOADX
program. For this purpose, click on the
button. The "Configuration" window will
open, in which you should click on the "Modem" tab. When you click on the
button, you will be able to edit parameters of the port used for communication with
the modem, as well as the initiation commands.
Initiating connection from the DLOADX program
This method makes it possible to establish connection with the control panel from any
location. Make sure that in the control panel:
• the computer telephone number has not been programmed!
• the ANSWERING – MODEM option is enabled (SERVICE MODE X3. GLOBAL PARAM.
X1. OPTIONS XMODEM ANSWERING);
• you have defined the number of rings after which the control panel will go off-hook
(SERVICE MODE X7. ANSWERING X1. RINGS TO ANS.);
• you have defined whether the control panel will go off-hook after the first, or after the
second call (S
ERVICE MODE X3. GLOBAL PARAM. X1. OPTIONS XDOUBLE CALL).
Telephone number of the control panel must be programmed in the DLOADX program.
1. Start the DLOADX program on computer.
2. Initialize the modem connected to the computer. For the modem to be initialized,
click on the button and, from the menu that will be displayed, select the 300 bps
modem. The window will then open where the modem initializing information will be
shown.
3. Click on the "Connect" button.
4. After the preprogrammed number of rings (after the second call, if the DOUBLE CALL
option is enabled), the control panel will answer the call and the connection will be
established. The DLOADX program will signal it by an appropriate message.
To Next Page
Loading...
