Satel VERSA Series - Access to Functions by Using Arrow Keys; Access to Functions by Using Numerical Shortcuts

SATEL VERSA 5
If the SERVICE MODE FROM RESET PINS option is disabled in the control panel (see:
Section GLOBAL OPTIONS) then, depending on the type of keypad in which the
lowest address is set:
– LCD: the , and LEDs of the second partition will be lit, and the
message "Restore factory settings ? 1=Yes" will come up on the display;
– LED: the and LEDs of the second partition will be lit and the LED
will be blinking rapidly.
Pressing the key with digit 1 will reset the control panel to its factory settings,
but will enable entering the service mode.
2.1.3 Access to functions by using arrow keys
This way of starting the function is only available in the VERSA-LCD-GR keypad.
1. Use the and keys to find the required submenu (the shape of submenu
cursor is: ).
2. Press the or key to enter the submenu (use the key to return to the
previous menu/submenus, and the
key to return to the main menu).
3. Repeat the steps described in 1 and 2 until you find the required function (the shape of
submenu indicating cursor is:
). Press the or key to start the function.
4. When entering new settings, accept them using the key and return to the submenu.
Press the key to cancel entering the new settings and return to the submenu.
2.1.4 Access to functions by using numerical shortcuts
This way of starting the function is available in both types of keypads supported by the
VERSA control panels (VERSA-LCD-GR and VERSA-LED-GR). All submenus and functions
are numbered. In order to enter a submenu, just press the key with number corresponding to
the submenu number. In order to start a function, press the key with number corresponding
to the function number, and then the key. You can quickly start the selected function by
entering at once a sequence of some digits (corresponding to the consecutive submenu
numbers and the function number) and confirming them by pressing the
key.
For example, to start the expander identification function, first enter the service mode and
then press in turn the
keys, where:
- enter submenu 2. HARDWARE;
- enter submenu 1. KPDS & EXPS.;
- start function 1. IDENTIFICAT.
In the VERSA-LCD-GR keypad, use the
key to return from a submenu to the main
menu or from a function to a submenu, and use the
key to return from a submenu to
the previous menu/submenu.
In the VERSA-LED-GR keypad, use the key to return to the main menu.
Notes:
• When using the numerical shortcuts, remember that the sequence of digits which starts
a function e.g. from the service mode main menu level will not start the same function
from the submenu level.
• In the LCD keypad, the shape of the submenu cursor is: , and that of the function
indicating cursor is :
.