Satel VERSA Series - Step by Step Programming Method; Service Mode Menu

6 Programming Manual SATEL
2.1.5 "Step by step" programming method
Some components of the system (e.g. zones, outputs, expanders, wireless devices, event
codes for monitoring, etc.) should be programmed using the "step by step" method. When the
function is called up and the component to be configured selected from the list, the first
parameter available for programming will be displayed. After it has been configured and
confirmed by pressing the key, you will automatically proceed to programming a next
parameter. The confirmed parameter is saved to the control panel memory. After all available
parameters are configured, return to the submenu follows in the VERSA-LCD-GR keypad,
and to the main menu in the VERSA-LED-GR keypad. The programming can be terminated
at any moment by using the key (you will return to the submenu). The and
LEDs of the first and second partitions show the programming step number in binary mode
(see: page 14 Table 4).
2.1.6 Service mode menu
Shown in square brackets are sequences which enable calling up a particular submenu or
starting a particular function from the main menu level.
0. SrvMod config
[00#] 0. Quit SrvMod
[01#] 1. VERSA id.
[02#] 2. DloadX id.
[04#] 4. DloadX tel.
[06#] 6. SrvMod opt.
[07#] 7. Restore all
[08#] 8. Default usr.
[09#] 9. STARTER
1. Partitions
[11#] 1. Part. 1 zones
[12#] 2. Part. 2 zones
[13] 3. Part. 1 times
[131#] 1. Exit delay
[132#] 2. Entry delay
[133#] 3. Warning
[134#] 4. Verification
[135#] 5. Autoarm delay
[136#] 6. A-arm defer
[14] 4. Part. 2 times
[141#] 1. Exit delay
[142#] 2. Entry delay
[143#] 3. Warning
[144#] 4. Verification
[145#] 5. Autoarm delay
[146#] 6. A-arm defer
[15#] 5. Part. 1 name
[16#] 6. Part. 2 name
[17#] 7. Part. options
2. Hardware