SATEL VERSA 57
The messaging is effected independently of the reporting, however the reporting has priority.
If, during the messaging, any events occur which must be reported by the control panel to the
monitoring station, the messaging will be interrupted. The control panel will resume the
messaging function after the event codes are sent to the monitoring station.
10.1 Messaging parameters and options
Round count – the number of event notification rounds to be completed by the control panel.
Values from 1 to 7 can be programmed.
Retries number for one round – the number of unsuccessful attempts to notify a single
telephone number about the event, after which the control panel gives up messaging to
that number for the current round. Values from 1 to 7 can be programmed.
Description – individual name of the telephone number (up to 16 characters).
Telephone number – the telephone number to which messaging is effected.
Note: The users having the P
ROGRAMMING right may edit the telephone numbers to be
notified by means of the T
ELEPHONE NUMBERS user function ([code] X6. SETTINGS
X4. TEL. NUMBERS).
Mode – selection of the form in which the indicated telephone number is to be notified (0 – no
messaging, 1 – PAGER1, 2 – PAGER2, 3 – voice message).
10.2 Event assignment
Enter the following information for the events of which the control panel is to notify:
• number of the text message by means of which messaging will be effected. If the
messaging is to be effected in the form of text messages, the voice message assigned to
the given text message will be used.
• telephone numbers to which the messaging will be effected if an event occurs.
10.3 SMS/Pager messages
The control panel makes it possible to program 64 different text messages to be used for
messaging notification. The text messages are numbered from 1 to 64. After the CA-64 SM
synthesizer is connected, one voice message of 16 available, can be assigned to each text
message. The voice messages are numbered from 0 to 15. The same voice message can be
assigned to several text messages.
10.4 Starting the messaging
1. Enable the TELEPHONE MESSAGING option (see: GLOBAL OPTIONS).
2. Define the mode of dialing the telephone numbers (global option TONE DIALING; in case of
the pulse dialing option – PULSE 1/1.5 (OFF 1/2)).
3. Determine whether the control panel, prior to dialing the number, should check the
telephone line for dialing signal (global option NO DIAL TONE TEST).
4. Determine whether the control panel is to play back the voice message after going off-
hook, or 15 seconds after the dialing is completed (global option N
O ANSWER TONE TEST).
5. Determine whether alarm clearing should cancel the messaging (global option C
LEAR
MESSAGING ON ALARM CLEARING
).
6. Define the number of attempts made by the control panel to notify about the event
(parameters ROUND COUNT and RETRIES NUMBER FOR ONE ROUND).
To Next Page
Loading...
