42 Programming Manual SATEL
their mutual operating range. For 12 s, the maximum number of devices is 150, for 24 s –
300, and for 36 s – 450. Outside the response period, information on device tampers and
on violations of active mode detectors is sent to the controller. Additionally, the RESPONSE
PERIOD
has an effect on the level of energy consumption by the wireless devices. The less
frequently communication between controller and wireless devices takes place, the lower
energy consumption and the longer battery life is.
Synchronize – the function starts the procedure of synchronization, i.e. checking whether
other ABAX wireless system controllers operate within the controller range. The
controller will adjust the response period so that radio transmissions from several
controllers should not be jammed by each other. Synchronization takes place
automatically on starting the controller and after each operation of adding/removing
devices supported by the controller.
Test mode – in the test mode, all wireless devices will signal communication with the
controller by blinking LED, and the detectors will signal violations and tampers on their
LED indicators. During normal operation of the wireless devices, the LED signaling is
switched off for energy-saving considerations. Siren signaling is disabled in the test mode.
The test mode is enabled/disabled during the response time, thus causing a delay, the
duration of which depends on the defined response period. The test mode will be
automatically exited after 30 minutes of:
– starting the test mode by using the DLOADX program (the 30 minutes' time runs from the
moment of exiting the controller settings),
– terminating the service mode in control panel.
Note: According to requirements of the EN50131 standard, the level of radio signals sent by
wireless devices is reduced during the test mode operation.
Fig. 14. Programming the settings of wireless system controller and wireless devices in the
DLOADX program (an example of configuration).
To Next Page
Loading...
