Satel Versa - Keys

SATEL VERSA 11
– fire alarm memory,
–
burglary alarm memory
,
– warning alarm memory,
– tamper alarm memory.
Both LEDs are used during the process of "step-by-step" programming to present the
number of current step (see: "STEP BY STEP" PROGRAMMING METHOD).
Yellow LED. Slow blinking of the LED means trouble or trouble memory. To find out
the cause of trouble, start the 7. SYSTEM STATE user function. The LED goes off when
in the armed mode.
On entering the user menu and in the service mode, the LED provides the following
additional information:
– LED blinking rapidly - navigation through the menu and submenus,
– LED ON - the function has been started.
Blue LED. The LED indicates that the service mode is active in the system. The LED
is lit on the keypad in which the service mode is running and the service function
menu is available. Blinking LED means that the service mode has been activated by
means of another keypad.
Note: If the GRADE 2 global option is enabled by installer:
–
the
LEDs provide information about alarms only after the code has been entered
and confirmed with the key;
– blinking of the LED means that there is a trouble in the system, some zones are
bypassed, or that there was an alarm.
6.4 Keys
12 keys are used for operating and programming the system. Basic uses of the keys when
operating the system are described below (when the user functions are applied and during
programming, the keys may be used to carry out other tasks).
... - use the keys bearing numbers and letters to:
– enter the code;
– select the partition to be armed (see: ARMING);
– quickly control the outputs (see: QUICK CONTROL OF OUTPUTS).
- press and hold down the key for approx. 3 seconds to trigger the medical
(auxiliary) alarm.
- press and hold down the key for approx. 3 seconds to enable/disable
chime signal in the keypad (signaling violation of selected zones by 5 short
beeps).
- press and hold down the key for approx. 3 seconds in the LCD keypad to
switch the display from normal mode to zone status presentation mode,
and vice versa. The function is not available, if the installer has enabled
the GRADE 2 option.
- use the key to:
– start the full arming procedure after entering the code (see: ARMING);