Satel Versa - Operating with Proximity Cards; Card Operation Signaling and Procedures

SATEL VERSA 43
7. Operating the Alarm System by means of Proximity Cards
The alarm system can be operated by means of proximity card, if a proximity card
arm/disarm device is connected to the control panel. Using the proximity card you can:
• arm the system in full mode;
• arm the system in mode A or B (the system behavior in case of arming in mode A or B is
defined by the installer).
• disarm the system;
• clear alarm in the system.
The installer determines the partitions to be controlled by the device. The user can only
control the partitions which he is authorized to access.
7.1 Signaling by means of LEDs
7.1.1 Signaling when the user holds up the card to the device
Red LED lit – after removal of the card, the procedure full arming in the partitions indicated
by the installer will begin.
Green LED lit – after removal of the card the procedure of mode A arming will begin (the
installer defines which partitions and in what mode will be armed – see PROGRAMMING
manual).
Yellow LED lit – after removal of the card r the procedure of mode B arming will begin (the
installer defines which partitions and in what mode will be armed – see PROGRAMMING
manual).
After the user takes the card away from the device, the LEDs may blink for a few seconds,
which provides the following information:
Rapidly blinking red LED – in the partition which is to be armed, the zone for which the
installer has enabled the PRIORITY option, is violated.
Rapidly blinking green LED – in the partition which is to be armed, an alarm zone beyond
the exit route is violated.
Rapidly blinking yellow LED – there is trouble in the system.
If none of the aforementioned situations occurs, the LEDs will start indicating the system
state as soon as the user takes the card away from the device face.
7.1.2 Information about system state
All LEDs extinguished – none of the partitions controlled by the device is armed or in alarm
condition.
Red LED lit, the other LEDs extinguished – all the partitions which are to be armed after
removal of the card when the red LED is lit are full armed.
Green LED lit, and the red one lit or slowly blinking – partitions controlled by the device
are armed in A mode (slow blinking of the red LED indicates alarm or alarm memory).
Yellow LED lit, and the red one lit or slowly blinking – partitions controlled by the device
are armed in B mode (slow blinking of the red LED indicates alarm or alarm memory).
Red LED lit, dimming momentarily, the other LEDs extinguished – at least one of the
partitions controlled by the device is armed.
Red LED lights up every 2 seconds, the other LEDs extinguished – alarm or alarm
memory, when none of the partitions is armed.
Red LED blinking slowly – alarm or alarm memory, when at least one of the partitions
controlled by the device is armed.