Satel Versa - Entering Digits

20 User Manual SATEL
[7#] 7. System state checking troubles / checking partition, alarm, trouble status
[8#] 8. Control controlling the outputs
[9] 9. Tests
[91#] 1. Zone test starting zone test
[92#] 2. Output test starting output test
[93#] 3. Wireless sig. checking level of radio signal from wireless devices
[94#] 4. Manual MS tst starting manual test transmission
[95#] 5. MS1 test test of telephone reporting to station 1
[96#] 6. MS2 test test of telephone reporting to station 2
[97#] 7. VERSA version checking firmware version of control panel
[98#] 8. Expander ver. checking firmware version of system modules
[99#] 9. Supply volt. checking current supply voltage in modules
[90#] 0. Outputs reset deactivating outputs / activating 21. DETECTORS RESETTING output
[0] 0. Service
[00#] 0. Service mode starting service mode
[01#] 1. Start DwnlTEL starting remote programming via telephone
[03#] 3. Start DwnlRS starting local programming
[04#] 4. Finish DwnlRS finishing local programming
[05#] 5. Serv. access defining service code access rules
[06#] 6. Access time defining service code access time
[07#] 7. ETHM-1DloadX establishing communication with DLOADX program via Ethernet
6.12.5 Entering digits
LED status
Digits and characters
0
– LED OFF
1
– LED ON
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Table 1. The binary mode of presenting digits and characters.