Satel Versa - Programming the Timers; Programming the Weekly Schedule

SATEL VERSA 33
Press suitable number keys to enter in turn the hour, minutes and seconds. After
pressing the key, the following data will be presented in binary format on the
LEDs:
year – only two last digits: first on LEDs 1-4, second – on LEDs 5-8;
month – first digit on LEDs 9-12, second – on LEDs 16-19;
day – first digit on LEDs 20-23, second – on LEDs 24-27.
Press suitable number keys to enter in turn the year, month and day, and then press
key.
6.20 Programming the timers
The VERSA control panels enable 4 timers to be programmed. Using the timers, you can
control the partition armed mode and the 15. CONTROLLED outputs. The timer compares the
time with the control panel clock and executes the selected function at a preset time. The
user having the PROGRAMMING right can edit the timer settings, i.e. the time parameters and
the armed mode activated by timer in the selected partition. The installer alone can define
which outputs will be controlled by means of timers.
1. Enter the user menu and press in turn the keys. 2 short beeps will
confirm entering the function, and the LED will go on. The programming is effected by
using the "step by step" method, hence the programming step will be presented in the
binary format on the and LEDs of the first and second partitions (see: page 20,
Table 1).
2. Step 1. Selecting timer to be programmed. Press in turn the suitable keys to select
a timer:
- timer 1;
- timer 2;
- timer 3;
- timer 4.
3. Step 2. Selecting parameters to be programmed. Press in turn the suitable keys to
select a parameter :
- weekly schedule;
- exception 1;
- exception 2;
- exception 3;
- exception 4;
- partition 1 arming mode;
- partition 2 arming mode.
Note: Irrespective of the selected parameter, pressing the key in a subsequent step
will take you back to Step 2.
6.20.1 Programming the weekly schedule
1. Step 3. Programming timer activation/deactivation time on Monday. Hour and
minutes of timer activation, and hour and minutes of timer deactivation should be
programmed (if the timer is not to be used on that day of the week, you can proceed at
once to the next step by pressing the key). Press suitable number keys to enter the
appropriate parameters. Programming both activation and deactivation times is not
required – you can just program one of them. If the time of activation or deactivation is not
to be programmed, you should enter here e.g. the 9999 sequence (even with one wrong