48 User Manual SATEL
9.1 Starting the operating by telephone
1. Dial the control panel phone number. The control panel will answer after a preset number
of rings or after the second call (depending on the preprogrammed settings). Establishing
connection will be signaled by three short beeps.
2. Enter the code from the telephone keypad and confirm by pressing #. 4 short beeps
followed by 1 long beep will confirm you have got access to the interactive voice menu. If
your code does not authorize you to get access, you will hear three long beeps in the
headset. If the code is invalid, the control panel will signal it by two long beeps.
Note: Entering a wrong code three times will trigger tamper alarm and block the call answer
function for 90 seconds.
3. Messages of the interactive voice menu will be played back. They will inform you which
telephone keys you should use to be able to operate the control panel.
9.2 Stopping the operating by telephone
1. Press
*
key.
2. Press in turn the 0# keys. The control panel will go on-hook.
10. Acknowledgement of Voice Messaging
If the INT-VG voice module is connected to the control panel, acknowledgement of voice
messaging is possible. A special 4-digit code is used to acknowledge messaging (see:
PROGRAMMING CODES TO ACKNOWLEDGE MESSAGING p. 36). Having received voice messaging,
enter the code from the telephone keypad. The messaging acknowledgement will cancel
telephone notification of the event. The installer can configure the control panel so that the
user, after acknowledgement of voice messaging, should automatically get access to the
interactive voice menu (see section OPERATING THE ALARM SYSTEM BY TELEPHONE).
To Next Page
Loading...
