Satel Versa - Buzzer; Beeps Generated When Operating

12 User Manual SATEL
– disarm the system and clear alarm after entering the code (see:
DISARMING AND ALARM CLEARING);
– activate output (see: QUICK CONTROL OF OUTPUTS);
– trigger the panic alarm (press and hold down key for approx. 3
seconds).
- use the key to:
– enter the user menu (after the code is entered);
– cancel started operations;
– deactivate output (see: QUICK CONTROL OF OUTPUTS);
– trigger the fire alarm (press and hold down key for approx. 3 seconds).
- use the key to start the full arming procedure (see: ARMING).
- use the key to start the night arming procedure (see: ARMING).
- use the key to start the day arming procedure (see: ARMING).
- use the key to:
– disarm the system and clear alarm after entering the code (see:
DISARMING AND ALARM CLEARING);
– defer auto-arming (press the key twice during the auto-arming delay
countdown);
– quickly check the partition status (press and hold down key for approx.
3 seconds). The function is not available, if the GRADE 2 option has
been enabled by the installer.
6.5 Buzzer
6.5.1 Beeps generated when operating
1 short beep – pressing any number key.
3 short beeps – confirmation of:
– starting the arming procedure (which is equivalent to arming if no exit delay has been
programmed for the partition),
– disarming and/or alarm clearing;
– selecting the partition which is to be armed or disarmed, or where alarm is to be cleared
– in such a case the keypad is waiting for the code to be entered;
– deactivating output (see: QUICK CONTROL OF OUTPUTS);
– disabling the chime signal in keypad with the key;
– switching over the LCD keypad display from the normal mode to the zone status
presentation mode, and vice versa, by means of the key.
4 short beeps and 1 long beep – confirmation of:
– activating output (see: QUICK CONTROL OF OUTPUTS);
– enabling the chime signal in keypad with the key.
1 long beep – some zones are bypassed (LCD keypad only when arming) or denial of
arming (some zones in the partition are violated or there is a trouble).
2 long beeps – pressing the , , , or key, if not preceded by
entering code or selecting a partition, or an invalid code.
3 long beeps – refusal to carry out a command (the user does not have the required
authority level or the function is not available).