28 User Manual SATEL
use the and keys to scroll through the list of available devices, displayed in
the lower line. In the LED keypad, the LEDs corresponding to the addresses of devices
connected to the control panel, while the and keys can be used to select one
of the devices (the LED corresponding to the selected device will start blinking). Having
selected the device, press the key (all LEDs will start blinking steadily in the
selected device).
28. Step 7b. Adding proximity card. Depending on the selected method:
– enter the card code by means of suitable keys (see: ENTERING HEXADECIMAL VALUES)
and press the key;
– bring the card close to selected device and take it away after a short while (the code
will only be sent after the card is taken away) – 2 short beeps in the keypad will
confirm that the card code has been read (3 long beeps indicate that adding the given
card is not possible). Bring the card again to the device and take it away after a short
while – 2 short beeps in the keypad will confirm that the card code has been re-read.
In the LCD keypad, suitable messages will be displayed, suggesting the user what to
do.
Note: Pressing the key in Step 7a or 7b means canceling the card addition. In case of
the LED keypad, the user adding procedure will be terminated, and in the LCD
keypad, you will be taken to Step 8.
29. Step 8. Giving name to user. This step is only available in the LCD keypad (in the LED
keypad, the user adding procedure will be terminated at an earlier step). Press the
suitable keys to enter the user name (see: ENTERING NAMES) and press key. 4 short
beeps and 1 long beep will confirm that the procedure has been completed.
Note: Pressing the key terminates the user adding procedure. The user will be added,
if the procedure is terminated at Step 5 or a next one (the code, user schedule
and partitions will have already been assigned to the user).
6.14.2 User editing
1. Enter the user menu and press in turn the keys. 2 short beeps will
confirm entering the function, and the LED will go on. User editing will be effected by
the "step by step" method, hence the programming step number is presented on the
and LEDs of the first and second partitions in binary format (see: page 20, Table 1).
2. Step 1. Selecting user whose data are to be edited. In the LCD keypad, you can make
your choice by scrolling through the list of users by means of the and keys. In
the LED keypad, the system users are presented by lit LEDs with numbers corresponding
to the user numbers, and the and keys allow you to select one of them (the
LED corresponding to the selected user will start blinking). In both keypads you can select
a user by using keys to enter his/her number. Having selected the user, press key.
3. Step 2. Changing user code. Proceed in the same way as when adding a new user.
4. Step 3. Selecting user schedule. Proceed in the same way as when adding a new user.
5. Step 4. Selecting partitions accessible to the user. Proceed in the same way as when
adding a new user.
6. Step 5. Editing 433 MHz keyfob. You can:
– skip this step and go over to the next one – press at once the key, or any other
key with a number from 4 to 9, and then press key;
– add a keyfob – press in turn the and
keys. The procedure runs in the
same way as when adding 433 MHz keyfob to a new user (Steps from 5a to 5h),
To Next Page
Loading...
