Satel Versa - Arming Without Partition Selection; Arming the Selected Partition; Quick Arming

14 User Manual SATEL
Notes:
• The day/night arming modes are available if the installer has defined which zones are to
be active in this armed mode.
• If exit delay is programmed for a partition, you can leave the partition through the exit
route without triggering alarm after the partition arming procedure has started. The
exception is when the partition is armed without exit delay.
6.7.1 Arming without partition selection
Enter the code, and then press the key, as required:
or - to arm in full mode;
- to arm in day mode;
- to arm in night mode.
Based on the user data, the control panel will define the partitions which are to be armed.
Start of the arming procedure should be signaled by 3 short beeps.
Note: Depending on the current partition status, pressing the key after the code has
been entered may also result in disarming or alarm clearing, hence it is recommended
to use the key for full arming.
6.7.2 Arming the selected partition
1. Indicate the partition which is to be armed (press one of the keys: - partition 1;
- partition 2).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Backlight of the keys will start blinking, which indicates that the
code must be entered.
3. Enter the code.
4. Press the key or press again the key corresponding to the selected arming mode.
Start of the arming procedure should be signaled by 3 short beeps.
Note: The above described method of arming can be used for keypads in which quick
arming is not allowed for by the installer, and in some other situations, when the quick
arming is not possible.
6.7.3 Quick arming
If the installer has allowed for the quick arming by means of a selected keypad, the arming is
possible without entering any code.
1. Indicate the partition(s) to be armed (press one of the keys: - partition 1; -
partition 2; or - both partitions).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Start of the arming procedure should be signaled by 3 short beeps.
Notes:
• The quick arming allows for the armed mode toggling from the night mode to the full
mode, and from the day mode to the full mode. In every other case, the procedure
described in section ARMING THE SELECTED PARTITION will apply.
• The installer can configure the system so that the quick arming can be impossible, if there
is a violated zone in the partition, or a trouble has occurred in the system.