44 User Manual SATEL
All LEDs blinking steadily – no communication with control panel.
7.2 Buzzer
7.2.1 Beeps generated when operating
If the SIGNALING CARD (HARDWARE) option is enabled, the device will generate a single short
beep after the card has been read and – if the card is held up – after each successive LED
comes on.
After taking the card away, the device can generate the following beeps:
3 short beeps – confirmation of starting the arming procedure (which is equivalent to arming,
if no exit delay has been programmed for the partitions), disarming or alarm clearing;
1 long beep – denial of arming (the zone for which the installer has enabled the PRIORITY
option is violated);
2 long beeps – unknown card;
3 long beeps – denial of arming / disarming, alarm clearing (the user does not have required
rights, or execution of the operation is impossible for other reasons, e.g. there no partitions
which can be disarmed or where alarm can be cleared).
7.2.2 Events signaled by sounds
Long beep every 3 seconds, followed by a series of short beeps for 10 seconds
and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only
the final sequence of short beeps will be generated).
A sequence of 7 beeps of diminishing duration, repeated every few seconds –
countdown of auto-arming delay.
2 short beeps every second – entry delay countdown.
Continuous beep – alarm (also warning alarm).
Long beeps separated by short pauses – alarm memory.
Long beep every second – fire alarm.
Short beep every 2 seconds – fire alarm memory.
Notes:
• Only installer selected events are signaled.
• Alarms are signaled during the KEYPAD'S ALARM TIME (programmed by the installer).
7.3 Arming
7.3.1 Full arming
1. Present the card to the device and hold up until the red LED comes on.
2. Remove the card from the device. Start of the arming procedure should be signaled by 3
short beeps.
7.3.2 Arming in mode A
1. Present the card to the device and hold up until the green LED comes on.
2. Remove the card from the device. Start of the arming procedure should be signaled by 3
short beeps.
7.3.3 Arming in mode B
1. Present the card to the device and hold up until the yellow LED comes on.
To Next Page
Loading...
