WARNING
To avoid any problems during operation of this control panel, it is recommended that you
familiarize yourself with this manual before you start using the equipment.
Making any construction changes or unauthorized repairs is forbidden. This applies, in
particular, to modification of assemblies and components. Maintenance and/or repair
operations should be performed by authorized personnel (i.e. the installer or factory service).
The control panel should only be connected to the analog subscriber lines. Connecting its
telephone circuit to a digital network (e.g. ISDN) may cause damage to the equipment. In
case of changing the analog line to the digital one, it is necessary to contact the alarm
system installer.
Pay special attention if the telephone line used by the control panel is frequently busy and/or
failures are reported, concerning the line and/or monitoring. Report such situations to the
alarm system installer immediately.
To ensure adequate protection, the alarm security system must be in good working order,
therefore SATEL recommends that it be regularly tested.
The alarm security system cannot prevent burglary, assault or fire from happening, but it
guarantees that in case of emergency measures will be taken to reduce the possible damage
(the alarm will be signaled optically and acoustically, appropriate services will be notified,
etc.), which may deter the potential burglars.
CAUTION!
The security alarm system is fitted with a battery. Do not throw the used-up battery away, but
recycle it as required by the existing regulations (European Directives 91/157/EEC and
93/86/EEC93/86/EEC).
The declaration of conformity may be consulted at www.satel.eu/ce
To Next Page
Loading...
