SATO S84NX - Page 138

S84NX/S86NX Service Manual
136
Back to top 6 Troubleshooting
Error Number Type of Error Error Icon LED Buzzer
1014
USB Memory Full
Light in red
Long
sound,
one time
Message USB memory full. Free up space.
To clear the display
Connect the USB memory with suffi cient space, or press the left select button
(OFFLINE) or LINE button.
Causes • The space in the USB memory is not suffi cient.
Countermeasures
• Delete unwanted data from the USB memory or insert a USB memory with
suffi cient space.
1017
SBPL Command Error Light in red
Short
sound,
3 times
Message C003:<X>:Invalid command
To clear the display Press the left select button (CANCEL) or LINE button.
Causes
Incorrect command or parameter is detected in the print data.
Check the display of “Caaa: <bb>: cc” for error details.
Caaa: Position of error occurrence
<bb>: Error command name
cc: Error content
The error contents are as follows:
Invalid command Analyzed improper command.
Invalid parameter Received improper parameter.
Command table read error Failed to read the command table.
Invalid graphic data/ custom designed data
Analyzed improper graphic and custom
designed data.
Invalid registration area
• Specifi ed memory area (card slot) is
inappropriate.
• Tried to write to a write-protected media.
This number is already registered.
Number specifi ed by registration command
has already been taken.
Over registration area limit Exceeded the registration area. (Memory full)
Data is not registered Data, such as form overlay, is not registered.
Printing position is out of printable area
The specifi ed print start position is outside
the printable area.
Barcode image is out of printable area
The printing image is outside the printable
area. (Barcode only)
Countermeasures
Check the print data.
If the problem persists, restart the printer.