SECTION IV
MAINTENANCE / SERVICE
Page 4-25Printed in U.S.A.
Figure 4-26. Seat Cylinder Removal / Installation
NOTE
Hand control may be used to run SEAT UP or SEAT
DOWN function to help align seat section weldment
with rod of seat cylinder.
(9) Align seat spar weldment (5) with rod of seat
cylinder (8) and secure with connecting pin (3),
making sure flat surface of connecting pin is
facing two setscrews (4) and threaded hole in
pivot pin is accessible through hole in side
weldment.
(10) Secure each connecting pin in place by tighten-
ing two setscrews (4).
(11) Install hole plug (1) in side weldment (2).
(12) Install back section table top (3, Figure 4-22)
on side weldment (4) and secure with four
screws (2).
(13) Install four plugs (1) on back section table
top (3).
(14) Install upper front bridge cover (8) by pressing
two posts of front bridge cover into two snap
receptacles (9).
(15) Install two cover gaskets (5) and bridge cover
(7) on R.H. and L.H. side weldments (4); then
bend lip of cover gaskets back and install four
screws (6).
(16) Add oil to reservoir (Refer to para 4.2).
(17) Perform seat cylinder synchronization procedure
(Refer to para 4.6).
© Schaerer Mayfield USA, Inc. 2004
To Next Page
Loading...