ScreenBeam 1100 Plus - V.3.10.1 Specifying ScreenBeam CMS for the Receiver

77
4. Click the Apply button, and then click OK on the pop-up message box to confirm.
V.3.10 Receiver Management Access Settings
This section introduces settings for receiver management.
V.3.10.1 Specifying ScreenBeam CMS for the Receiver
To specify a CMS server for the receiver, follow this procedure:
1. Go to the Management Access tab page by clicking the Management Access tab.
2. Go to the Central Management System Settings section, and define the CMS Server
and the CMS Communication Port.
 CMS Server: It is the IP address or the FQDN/hostname/domain name/alias name (if a
DNS server and an DHCP server are properly configured) of the server that hosts the
ScreenBeam CMS. It supports a domain with six labels at most.
Note: It is recommended to use DNS configuration for CMS Server.
 CMS Communication Port: It is the communication port of the ScreenBeam CMS. The
port range is from 5000 to 65535. By default, 7237 is used.