ScreenBeam 1100 Plus - V.3.10.2 Specifying a Port for the Receiver’s LMI

78
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
V.3.10.2 Specifying a Port for the Receiver’s LMI
To specify a communication port for the receiver’s local management interface, follow this
procedure:
1. Go to the Management Access tab page by clicking the Management Access tab.
2. Go to the Central Management System Settings section, and define a port for Web
Communication Port.
 Web Communication Port: It is the communication port for the receiver’s Local
Management Interface. The port range is from 5000 to 65535 (except 5555). By default,
443 is used.