93
5. Measuring Light Sources [Measurement Screen]
2.
Touch the [Target] indication.
Target CCT Input screen will be displayed. (
P26)
Set the color temperature.
NOTE
●
If you are not using LB index/lter and CC index/lter values, you can omit this step.
●
You cannot set the target color temperature in "Spectrum Comp.", "CRI", "CRI
Comp.", "SSI", "TLCI/TLMF" and "Multi Lights" Modes.
3.
Connect the sync cord (sold separately) to the Sync Terminal ⓬
of the meter.
CAUTION
Depending on the ash equipment used, the
ash may be triggered when the sync cord is
connected to the Sync Terminal
⓬
or when
operating the Power Button
❸
. Because there
is the possibility of burns or negative effects
on vision, please handle with care.
&
Power Button
❸
Sync Terminal
⓬
Measuring Screen Target CCT Input Screen
To Next Page
Loading...
