5
2. Before Use
2-3 Power ON/OFF
Power ON
1.
Turn the Light Selection Ring 2 to set to the
dark calibration position ( ).
2.
Press the Power Button 3.
The meter will turn on and the Startup screen will be
displayed (for 2 seconds).
NOTICE
●
The blue lettered "SEKONIC" logo screen is displayed
after battery replacement and 24 hours after power OFF.
●
The meter is executing a memory check while the blue
progress bar is moving on the Logo Screen, so please
do not turn OFF the power, as doing so may lead to
damage.
NOTE
●
If the LCD screen shows no display, check if the batteries are installed properly (Pos/Neg
positioning) and have enough capacity.
●
You can reduce start up time by simply tapping the screen when the Startup screen
appears.
Logo Screen
&
Power Button
3
Light Selection Ring
2
Startup Screen
To Next Page
Loading...
