Sekonic SPECTROMASTER C-800 - Measurement in Cord (PC) Flash Mode

92
5. Measuring Light Sources [Measurement Screen]
5-4 Measurement in Cord (PC) Flash Mode
Cord (PC) Flash Mode is preferable when lighting conditions prevent the use of
cordless measurements or when certain types of equipment require a physical sync
connection.
In Cord (PC) Flash Mode, the meter and ash unit are connected with a Sync Cord
(sold separately).
CAUTION
●
Do not handle this product with wet hands, or leave it in the rain or in a
location where it may be splashed with water, submerged, or come into
contact with moisture. There is a danger of electric shock in Cord (PC) Flash
Mode. This may also result in damage to the product.
●
When using ash with high voltage, there is a danger of electric shock if
you touch the Sync Terminal
⓬
. Handle the ash with care when using for
measurement.
Operation
1.
On the Measurement screen, touch the [Measuring Mode] icon
and select the [Cord (PC) Flash Mode] icon on the Measuring
Mode Selection screen.
Select the measuring mode. (

P22)
Measuring Screen
Measuring Mode
Selection Screen
Measuring Screen