91
5. Measuring Light Sources [Measurement Screen]
CAUTION
●
Do not trigger ash while skin or other objects are in contact with the ash
tube. Do not touch the ash tube after repeated ashes. (It may cause
burns.)
●
Do not trigger ash while near the eyes of people or animals. (It may
temporarily affect vision.)
●
The ash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
●
When using Cordless Flash Mode, the LCD screen backlight dims during
measurement, and the LCD backlight is illuminated for only 3 seconds after
measurement. To cancel standby mode, touch the screen or press the Menu
Button
❻
.
In case of the following, please follow "5-4 Measurement in Cord (PC) Flash Mode"
(
P92)
●
If the ash output power is too weak compared to the surrounding light, the meter
may not detect the ash output.
●
Pulsed light sources such as uorescent lights or special lighting could cause the
meter to take cordless ash measurements in rare cases.
●
If the Light Receptor
❶
detects a sudden and bright change in lighting intensity,
the meter may mistakenly take a measurement.
●
Because the light radiated from a ash bulb gradually builds, the meter will not
detect the light when used in Cordless Flash Mode.
NOTE
●
When using the meter in Cordless Flash Mode, it is possible to mount the meter to a
light stand, tripod or similar support using the Tripod Socket
❿
.
●
[Over] or [Under] will be displayed if the light source illumination is too bright or not
bright enough, or if the color temperature is out of the measurement range, when the
Measuring Button is pressed. In this case, adjust the brightness or color temperature of
light source, or switch the light range. (
P99)
To Next Page
Loading...
Need help?
General
