4
2. Before Use
2-2 Installing the Batteries
1.
Prepare two AA batteries.
2.
Slide the Battery Cover Latch 8 in the direction of the arrow and
remove the Battery Cover 9.
3.
Insert the batteries according to the "+" and "-" symbols in the
Battery Compartment d.
* As shown in the diagram below, please note both positive sides of the batteries are
facing in the same direction.
4.
While lining up the two tabs on the Battery Cover 9, press the
Battery Cover 9 back into place from above.
WARNING
Do not place batteries in open ames, attempt to short, disassemble, apply
heat to, or recharge them (except rechargeable batteries). They may burst and
cause res, serious injury, or damage to the environment.
CAUTION
●
Use the manganese or alkaline batteries.
●
Do not use batteries with any other rating than the one specied.
Also, do not mix old and new batteries.
●
Please insert the batteries minus "-" side rst.
When removing the batteries, remove them plus "+" side rst.
●
lf the meter will not be used for an extended period of time,
it is recommended to remove the batteries to avoid possible damage caused
by battery leaking.
TabsBattery Cover Latch
8
Battery Cover
9
Battery Compartment
d
To Next Page
Loading...
