Sekonic SPECTROMASTER C-800 - Changing the Light Range

101
5. Measuring Light Sources [Measurement Screen]
5-6-2 Changing the Light Range
Change and use the light range depending on the brightness of the ash.
Light Selection Ring
(Status Bar Display)
Content
Dark Calibration
Position
Select for dark calibration only. Measurement cannot be
made in this position.
Range L
Select for ALL ambient light measurement, and low
power ash units (lower than 640lx·s/59.5fc·s)
Range H
Select for powerful ash units (brighter than
580lx·s/53.9fc·s) only.
Turn the Light Selection Ring
❷
and select the desired range.
The set range will be displayed on the LCD screen's status bar.
Status Bar
Light Selection Ring
❷
RANGE H
RANGE L
RANGE L
RANGE H