81
4. Basic Operations
4.
Press the Measuring Button ❺ to measure.
The Light Selection Ring
❷
should be set to L ( )
when taking ambient light measurements.
When measuring ash units, select Range L ( )
or Range H ( ) depending on the brightness of
the ash. (
P99,
P101)
Measurements are now displayed.
NOTE
Measurements and display will take longer in light levels below 30lx. The LCD
illumination will normally switch off during measurements to avoid inuence to
measurements.
5.
The red point shows the correction value from the target color
temperature.
6.
Memorize the measurement results.
To record measurements, press Memory Button
❼
. (
P106)
C-800
Light Selection Ring
❷
Measuring Button
❺
Displays value per one grid
Displays corrected value
To Next Page
Loading...
