Date Code 20170207 Field Reference Guide SEL-734B Capacitor Bank Control
Section 1
Overview
Introduction
The SEL-734B Capacitor Bank Control, with low-energy analog (LEA)
inputs, provides advanced capabilities for capacitor bank control and feeder
monitoring. Design templates are custom settings interfaces, built for the Full-
Size Enclosure and Compact Enclosure models, which configure the
SEL-734B for capacitor bank control.
This Field Reference Guide describes procedures by which the user can
perform the following actions.
➤ Install any type of SEL-734B enclosure model
➤ Establish initial communications
➤ Configure critical settings applicable to all design templates
➤ Commission, troubleshoot, and test the system
For model-specific operation and functions, please refer to the appropriate
design template guide, located at selinc.com.
SEL offers the SEL-734B device installed inside of an outdoor-rated
enclosure and preconfigured for capacitor bank control. Figure 1.1 shows the
SEL-734B model options.
Figure 1.1 SEL-734B Model Options in Outdoor-Rated Enclosures
NOTE: The SEL-734B is also available
as a loose device, not installed in an
enclosure and not programmed for
capacitor bank control.
Full-Size Enclosure
Compact Enclosure Options
(4-Jaw, 6-Jaw, 7-Pin)
SEL-734B Device
To Next Page
Loading...