4.5
Date Code 20170207 Field Reference Guide SEL-734B Capacitor Bank Control
Configuring the SEL-734B
Change Passwords
Using the Front-Panel
Menu
Step 1. Press ENT.
Step 2. Select the
Set/Show menu and press ENT.
Step 3. Select the
Set Password menu and press ENT.
Step 4. Select
EAC to set the Access Level E password. Select 2AC to set
the Access Level 2 password. Press ENT. The SEL-734B will
prompt you for the present Access Level 2 password.
Step 5. Use the arrow buttons to navigate the text entry screen and
enter the present Access Level 2 password. The SEL-734B will
now prompt you for the new password.
Step 6. Use the arrow buttons to navigate the text entry screen and
enter the new password.
Using a Terminal
Program
Step 1. Establish communication to the SEL-734B.
Step 2. Click the QuickSet Terminal icon ( ) on the header ribbon
or open a terminal program and establish SEL ASCII
communication to the device.
Step 3. Enter Access Level 2.
a. Enter the ACC command.
b. When prompted, enter the Access Level 1 password.
c. Enter the 2AC command.
d. When prompted, enter the Access Level 2 password.
Step 4. Enter the following command syntax: PAS n password, where
n is the password level to change (1, E, 2) and password is the
new password.
Step 5. The SEL-734B responds with
Set when the password has been
changed.
NOTE: To view the present password,
enter the command without the
password parameter.
To Next Page
