Using the EK IEM G4
62
Reset
▷ Select Reset List to delete the list of unused frequencies.
Performing multi-channel frequency setup
As an alternative to the following procedure, multi-channel frequency
setup can also be performed using the Sennheiser Wireless Sys-
tems Manager (WSM) software. For more information about con-
trolling devices via the Sennheiser Wireless Systems Manager (WSM)
software, refer to the instruction manual for the software. You can down-
load the software here:
www.sennheiser.com/wsm
To perform the automatic frequency setup for multiple radio links simulta-
neously:
▷ Connect all of the SR IEM G4 transmitters to one network using a net-
work switch. See “Creating a data network”.
The automatic frequency setup function only works for transmitters in
the same frequency range. Transmitters in a different frequency range
are not included.
▷ Please note that all transmitters must be in the same IP address range.
• The IP addresses can be automatically assigned if there is a DHCP
server in the network.
• If there is no DHCP server in the network, the IP addresses must be
assigned manually. See “Advanced > IP Address menu item”.
• Assign the IP addresses for all transmitters in the 192.168.x.x range
(the link-local range 169.254.x.x is also a possible alternative).
To Next Page
Loading...
