Using the EK IEM G4
66
▷ Select an unused frequency for one of the connected transmitters on
the master transmitter.
The frequency selected on the master transmitter will also be shown on
the display panel of the connected transmitters.
▷ Press the jog dial (SET) on the particular transmitter to save your se-
lected frequency and synchronize it with the corresponding receiver at
a later point (see “Synchronizing devices”).
or
▷ Press the SYNC button to synchronize the selected frequency with the
receiver immediately.
▷ Use this procedure to assign an unused frequency to all connected
transmitters, one after another.
▷ For the last step, assign a frequency to the master transmitter.
This completes the multi-channel frequency setup.
To Next Page
Loading...
