Sharp VL-PD6H

SmartMedia Card
Features
76
100- 0001NORMAL
END
[
DI AL PUSH
]
P- IN-P
6
2 3
6
4
1
5
COMPOS I T E
P- IN-P
END
TITLE/SCENE
100- 0001NORMAL
END
[
DI AL PUSH
]
P- IN-P
6
2 3
6
5
4
1
Q
W
PUSH
PUSH
SHUT. SPEED
PI CTURE EFF.
QU I CK RE TURN
:
OFF
-----------
2
----------
-----------
3
----------
M ENU
COMPOS I T E
P- IN-P
END
TITLE/SCENE
COMPOS I TE
AUTO
Q
W
PUSH
Combining Inset Still Images
Tape Recording mode
1 Insert the recorded SmartMedia card in
the camcorder.
2 Set the camcorder to Tape Recording
mode, and then press the MENU/
DISPLAY button until the menu screen
appears.
3 Turn the SET-PUSH dial (Q) to select
“COMPOSITE”, and then press the dial
(W) to display the composite picture
selection screen.
4 Turn the SET-PUSH dial (Q) to select
“P-IN-P”, and then press the dial (W) to
display a thumbnail of the images
recorded on the SmartMedia card.
5 Press the B (Next Image Selection) or
C (Previous Image Selection) button to
move the selection frame to the desired
image.
• To display a thumbnail of the next (or
previous) 6 images, move the selection
frame to the image at the bottom right (or
top left), and press the B (or C)
button.
7 Press the REC START/STOP button at
the point where you want to begin
recording.
• The subject is recorded with the inset still
image.
Card Recording mode
1 Perform step 1 above.
2 Set the camcorder to Card Recording
mode, and then press the MENU/
DISPLAY button until the menu screen
appears.
3 Perform steps 3 to 6 above.
4 Press the STILL button to capture the
subject with the inset still image.
5 Press the REC START/STOP button to
begin recording.
To delete the inset still image
Press the SET-PUSH dial.
6 Press the
(Set) button.
• The selected still image is displayed
inside the inset window.
ENDEND
[
D I AL PUS H
][
D I AL PUSH
]
Selection frame
VL-PD6H/075-078 01.4.24, 0:44 PM76
Downloaded from: http://www.usersmanualguide.com/