SICK CLV 421

Operating Instructions Chapter 10
CLV 42x bar code scanner
Appendix
8 009 981/O078/16-08-2004 © SICK AG · Division Auto Ident · Germany · All rights reserved 10-37
If the software version on the new device is more recent than that on the old one, the default
settings in the imported parameter set will include parameters that were not contained in
the old version.
 Upload the parameter set from CLV to CLV Setup and check whether the new
parameters are relevant for configuring the CLV for the current reading application. If
necessary, change the parameter values and download the parameter set to the CLV
again. Save the new parameter set as a configuration file in CLV Setup.
See also Chapter 10.4.10 Dealing with unknown parameters, Page 10-15.