Chapter 1 Operating Instructions
CLV 42x bar code scanner
1-2 © SICK AG · Division Auto Ident · Germany · All rights reserved 8 009 981/O078/16-08-2004
Notes on this document
1.4 Symbols used
Some of the information in this document is marked specially so that you can access it
quickly:
Warning
Warnings are provided to prevent injury to operating personnel or serious damage to the bar
code scanner.
Always read warnings carefully and observe them at all times.
Note Notes indicate special features or characteristics.
Explanation Explanations provide background information on technical correlations.
Recommendation Recommendations help you carry out certain procedures more effectively.
Tip Tips explain settings in the user interface of the CLV Setup program.
Default setting Marks a section containing the values of the factory default settings.
SCANNING FREQUENCY This font indicates a term in the user interface of the CLV Setup program.
Icons refer to buttons in the user interface of the CLV Setup program.
"Host receive fault" This font indicates messages output via the terminal interface of the CLV.
This symbol identifies sections that describe steps carried out with the user interface of the
CLV Setup program.
This symbol is used to mark sections that describe steps carried out with the profile
programming.
This symbol refers to additional technical documentation.
An action must be performed. This symbol identifies single-step instructions.
Instructions consisting of several steps are numbered consecutively.
Here you select a function of the user interface of CLV Setup.
To Next Page
Loading...
Need help?
General
