Operating Instructions Chapter 1
CLV 42x bar code scanner
Notes on this document
8 009 981/O078/16-08-2004 © SICK AG · Division Auto Ident · Germany · All rights reserved 1-1
1 Notes on this document
1.1 Function
This document contains instructions for operating the following bar code scanners:
• CLV 420 standard range, with fixed focus
• CLV 421 long range, with fixed focus
• CLV 422 high density, with fixed focus
in the variants
• Line scanner without/with 105° angle attachment
• Raster scanner without/with 105° angle attachment.
This document provides information on
• Installation and electrical connection
• Startup
• Operation and configuration (parameterizing)
• Maintenance
• Replacing the device while retaining the parameter set
• Special applications and procedures.
The bar code scanners will all simply be called "CLV" below, except in such text passages
where a differentiation is required.
1.2 Target audience
This document is intended for persons who are responsible for the following activities:
1.2.1 Installation, electrical connection, maintenance and replacement
Electricians and service technicians
1.2.2 Startup, operation and configuration
Technicians and engineers
1.3 Information content
This document contains all of the information required to install, make electrical connections
and start up the CLV with the factory default settings.
A series of step-by-step instructions is provided for each of these activities.
The CLV is configured for specific applications using the Windows-based "CLV Setup" and
"CLV Assistant". Further assistance is also available in the form of the online help system
"CLV Setup Help". The procedure for installing and operating the user interface of the
software is described in the Appendix.
For further information on the design of the bar code scanner or on bar code technology in
general, please contact the Auto Ident division at SICK AG.
Internet address: www.sick.com.
To Next Page
Loading...
Need help?
General
