1 About this document
1.1 Purpose of this document
These operating instructions contain the information required during the life cycle of the
s
afety system. This document describes:
•
The individual components
•
The project planning
•
The mounting and electrical installation, insofar as special measures are neces‐
sary for the safety system
•
The configuration
•
The necessary thorough checks
•
The commissioning
•
The maintenance
•
The troubleshooting
1.2 Scope
These operating instructions contain information regarding the Safe Linear Positioning
s
afety system.
NOTICE
T
he operating instructions of the components also apply. In the event of contradictions
between the operating instructions, the information specified in the operating instruc‐
tions for the safety system applies.
The relevant information must be made available to the employees for all work per‐
formed on the safety system.
The following documents contain information regarding the Safe Linear Positioning
s
afety system:
Table 1: Documents available for Safe Linear Positioning
Document type Title Part number
Operating instructions OLM100 Hi linear measure‐
ment sensor
8014310
Operating instructions Flexi Soft in the Flexi Soft
D
esigner software
8012998
Operating instructions Flexi Soft modular safety con‐
troller hardware
8012999
This document is included with the following SICK part numbers (this document in all
available language versions):
8020939
1.3 Target groups and structure of these operating instructions
These operating instructions are intended for the following target groups: project devel‐
oper
s (planners, developers, designers), installers, electricians, operators, and mainte‐
nance personnel.
These operating instructions are organized by the life phases of the safety system:
project planning, mounting, electrical installation, commissioning, operation and main‐
tenance.
ABOUT THIS DOCUMENT 1
8020941/12O9/2019-08-05 | SICK O P E R A T I N G I N S T R U C T I O N S | Safe Linear Positioning
7
Subject to change without notice